Recoat (Buff & Coat) in Columbus, OH
A quick, low-cost refresh — buff the existing finish and add a fresh protective coat without a full sand.
Recoat (Buff & Coat) in Columbus, OHRecoat (Buff & Coat) done right for Columbus homes
A quick, low-cost refresh — buff the existing finish and add a fresh protective coat without a full sand.
Recoat (Buff & Coat) project in Columbus, OHIf your floors are dull and lightly worn but not damaged down to the wood, you may not need a full refinish at all. A buff-and-coat (screen-and-recoat) abrades the existing finish and lays down a fresh topcoat — restoring sheen and protection in a single day for far less than a full sand. The trick is catching it before the finish wears through to bare wood.
Our Recoat (Buff & Coat) Process
- 1
Finish Test
We confirm the existing finish is intact (not worn to bare wood) and compatible with a new coat — a quick water-drop and adhesion check.
- 2
Clean & Prep
We deep-clean to remove residue that would keep a new coat from bonding.
- 3
Buff / Screen
We abrade the existing finish so the fresh coat grips, hitting edges and corners by hand.
- 4
Recoat
We apply a fresh protective topcoat for renewed sheen and wear protection.
- 5
Cure Guidance
We review short cure and re-entry times — recoats are usually back in service quickly.
When a recoat is the smart call
- One-day refresh for lightly worn floors
- A fraction of full-refinish cost
- No sanding dust and minimal disruption
- Extends the life of your existing finish
- Best done before wear reaches bare wood
- Honest test first — we won't recoat a floor that needs a full sand
Recoat (Buff & Coat) detail and finish in ColumbusServing Greater Columbus
Refinishing hardwood across Columbus neighborhoods and suburbs, from German Village to Dublin.
Recoat (Buff & Coat): FAQs
What's the difference between a recoat and a refinish?
A refinish sands to bare wood and rebuilds everything; a recoat just abrades and adds a fresh topcoat over an intact finish. Recoats are cheaper and faster but only work before the finish wears through. We test to see which you need.
How often should I recoat?
Many homes benefit from a recoat every few years in high-traffic areas — far cheaper than waiting until a full refinish is required. Catching it early is the most economical way to maintain hardwood.
Can you recoat over wax or damaged finish?
Waxed floors and worn-through or peeling finishes usually can't take a simple recoat — the new coat won't bond. In those cases we recommend a full refinish, and we'll explain why.
How soon can we use the floor?
Recoats typically allow light foot traffic within hours and furniture within a day or two depending on the product. We give you exact timing.